Engineering · Machining guide
How to machine Hastelloy C-276.
Hastelloy C-276 is the gold standard for aggressive-chemistry corrosion resistance — better than Inconel for chloride and sulfuric environments, better than stainless across the board. The trade-off is among the worst machinability ratings of any common engineering alloy. Sub-20 machinability rating means slow speeds, premium tooling, and patience. The strategy mirrors Inconel — but slower.
01 · Hastelloy vs Inconel
Tougher in every way.
Hastelloy C-276 and Inconel 718 share the same fundamental machining problem — low thermal conductivity concentrates heat at the cutting edge. The differences:
- C-276 is even tougher to cut — molybdenum at 16% (vs Inconel’s ~3%) and tungsten at 4% create more cutting-edge wear
- Solid-solution hardened only — no precipitation hardening, no “machine soft, age later” trick. C-276 ships in solution-annealed condition and stays that way
- More expensive — $50–80/lb stock cost vs $35–50 for Inconel 718
- Better corrosion resistance — handles oxidizing AND reducing acids, chloride pitting, sulfuric attack. The reason customers pay the premium
For broader nickel-alloy comparison, see Inconel vs Hastelloy vs Monel.
02 · Cutting parameters
Slow and patient.
| Operation | Tool | SFM | IPT / IPR |
|---|---|---|---|
| Roughing turn | Coated carbide | 20–35 | 0.010–0.018 IPR |
| Roughing turn | Whisker ceramic | 500–700 | 0.006–0.012 IPR |
| Finishing turn | Coated carbide | 40–60 | 0.005–0.008 IPR |
| End mill (rough) | Solid carbide | 20–35 | 0.001–0.003 IPT |
| End mill (finish) | Solid carbide | 40–60 | 0.0008–0.002 IPT |
| Drilling | Solid carbide | 15–25 | 0.0008–0.002 IPR |
Whisker-reinforced ceramic for roughing follows the same playbook as Inconel — we run it in production and can share the operational detail on request.
03 · Practical notes
Same Inconel discipline, more of it.
- Tooling: sub-micron-grain coated carbide (PVD AlTiN). Honed cutting edges. Sharp geometry to minimize cutting pressure. Whisker ceramic for high-MRR roughing.
- Coolant: high-pressure flood with EP additives. Through-tool coolant where available. Carbide flooded; ceramic dry.
- Don’t reduce feed: same as Inconel — reducing feed lets the tool dwell and work-harden the surface. Maintain proper chip load.
- Replace tools on schedule: tool failure is sudden in C-276. Cycle-count tool changes; don’t wait for failure.
- Climb mill always: conventional milling re-cuts chips and accelerates work-hardening.
- Common applications: chemical-processing valve trim, scrubber fans, pollution-control hardware, exhaust system components for sour-service environments.
Keep exploring
Related tools & references
Nickel-moly-tungsten corrosion alloy properties.
Pick the right nickel alloy for the environment.
Set the slow SFM C-276 demands of carbide tooling.
Hold chip load to avoid work-hardening the surface.
8.89 g/cc — stock weights for premium alloy.
Technically reviewed by the True Precision Machining engineering team · Last reviewed June 2026
Standards referenced: AMS 5750
Need Hastelloy C-276 parts machined?
Send your drawing — Hastelloy C-276 is a material we run regularly. Aerospace, medical, and defense work welcome.
Quotes in 24 hours